好爽又高潮了毛片免费下载,国产97在线 | 亚洲,亚洲一区二区三区AV无码,特级AAAAAAAAA毛片免费视频

行業產品

  • 行業產品

樂清威創防爆科技有限公司


當前位置:樂清威創防爆科技有限公司>>防爆燈具類>>BAYD(BYY)防爆標志燈>>防爆標志燈,BAYD防爆標志燈,BYY防爆安全出口燈

防爆標志燈,BAYD防爆標志燈,BYY防爆安全出口燈

返回列表頁
參  考  價面議
具體成交價以合同協議為準

產品型號

品       牌

廠商性質生產商

所  在  地溫州市

聯系方式:江鵬龍查看聯系方式

更新時間:2018-05-14 09:00:00瀏覽次數:532次

聯系我時,請告知來自 智慧城市網

產品簡介

防爆標志燈,BAYD防爆標志燈,BYY防爆安全出口燈適用于Ⅱ類B級T6組及以下級別、組別的爆炸性氣體混合物(1區和2區)場所,在50Hz、電壓至220V的線路中作為一般照明和應急照明、指示通道和安全出口之用。

詳細介紹

防爆標志燈,BAYD防爆標志燈,BYY防爆安全出口燈
BAYD (BYY) byy
1、用途與適用范圍
1, application and applicable scope
BAYD系列隔爆型標志燈(以下簡稱標志燈)根據國家標準GB2000.1《爆炸性環境用防爆電氣設備 通用要求》、GB2000.2《爆炸性環境用防爆電氣設備 隔爆型電氣設備“d” 》有關規定制造。適用于Ⅱ類B級T6組及以下級別、組別的爆炸性氣體混合物(1區和2區)場所,在50Hz、電壓至220V的線路中作為一般照明和應急照明、指示通道和安全出口之用。
BAYD series explosion-proof lights (hereinafter referred to as the marker lamp) according to the national standard GB2000.1 "electrical apparatus for explosive gas atmospheres General requirements", GB2000.2 "electrical apparatus for explosive gas atmospheres flameproof electrical apparatus" d "" the relevant provisions of manufacturing. Explosive gas mixture is suitable for level, class II B and below T6 group division (1 and 2 areas) sites, in the 50Hz, 220V voltage to the circuit as a general lighting and emergency lighting, indication channel and exit for.
本系列產品的制造還符合國家標準GB2894-82和GB2893-82的規定。
This series of products are in conformity with the provisions of the national standard GB2894-82 and GB2893-82.

BAYD防爆標志燈產品型號和意義及主要參數
2, the product model and the significance and the main parameters
2.1 產品型號和意義
2.1 types of products and the significance
BA YD- 3 / 3 □ □
3 / 3 - BA YD
M:安全出口
M: exit
標志種類 J:向左
Mark J: left
K:向右
K: right
G:吊桿式
G: derrick
安裝形式 X:吸頂式
Installation: ceiling type X
B:墻壁式
Wall type: B
應急功率
Emergency power
正常照明功率
The normal illumination power
誘導標志燈
Induction of marker lamp
防爆
Explosion-proof
2.2 主要參數
2.2 main parameters
額定電壓V 額定功率W 光 源 應急照明
Emergency lighting rated voltage V, rated power W light source
時間min
Time min
充電24h后 引入裝置 質量
Introduction device quality charging 24h
kg
Kg
正常照明 應急照明 正常 應急 正常 應急 出線管螺紋G" 導線截面
Normal lighting and emergency lighting normal emergency normal emergency outlet pipe thread G "wire section
(不小于mm2)
(less than mm2)
110V
110V
400HZ 110V
400HZ 110V
400HZ 3 3 場致發光屏 90 3/4 1.5 8.5
400HZ 33 electroluminescent screen 90 3/4 1.5 8.5
BAYD防爆標志燈在下列情況下能夠可靠工作
3, marker lamp can work reliably in any of the following circumstances
3.1 周圍空氣溫度上限值不超過+50℃,下限值不低于-10℃;
3.1 the temperature of the air around the upper limit of not more than +50 ℃, lower value not lower than -10 ℃;
3.2 安裝地點的海拔不超過2000m;
3.2 installation site elevation not exceeding 2000m;
3.3 在無顯著搖動、振動和沖擊的地方;
3.3 significant shake, no vibration and shock;
3.4 安裝地點zui濕月平均zui大相對濕度不超過95%,
3.4 installation location the wettest month average maximum relative humidity of not more than 95%,
3.5 在無破壞金屬和絕緣的腐蝕性氣體或蒸氣的地方;
3.5 in no destroy metal and corrosive gas or vapor place insulation;
3.6 在能防止雨雪及滴水侵襲的地方;
3.6 can prevent rain and snow and water invasion;
3.7 污染等級為3級;
3.7 of the pollution level of 3;
3.8 防護等級:IP65。
3.8 protection grade: IP65.
BAYD防爆標志燈結構概述
4, the structure overview
標志燈由主腔、觀察窗、發光標志牌、接線腔(兼吸壁或吸頂、吊桿底座)及安裝在主腔內的應急裝置,接線盒等組成,主腔和接線腔通過隔爆型接線端子連接。透明標志牌采用聚碳酸脂制成,表面印刷或鏤空“安全出口”、“向左”、“向右”等字樣或圖案。標志燈內、外均設有接地螺釘,用戶使用時應可靠接地。
Marker lamp is composed of a main cavity, an observation window, the luminous signs, wiring cavity (and absorbing wall or ceiling, derrick base) and installed in the main chamber of the emergency device, composed of junction box, the main cavity and a wiring cavity flameproof wiring terminals are connected through. The transparent sign in the polycarbonate materials, surface printed or engraved "exit", "left", "right" and other words or patterns. Marker lamp, are provided with a grounding screw, shall be reliably grounded when users.
BAYD防爆標志燈安裝使用與維修
5, installation and repair
5.1 安裝前應檢查標志燈銘牌上所列數據與實際使用條件是否相符。
5.1 installation should be checked before the lights nameplate on the column data and actual conditions of use is consistent with the.
5.2 標志燈應可靠接地。
5.2 lights should be reliable grounding.
5.3 安裝及維修后,應將引入裝置的密封圈壓緊,以確保其密封性能。
5.3 installation and repair, should be introduced device sealing ring is pressed, in order to ensure the sealing performance.
5.4 維修時必須斷開前極電源后開蓋。
5.4 repair must be disconnected before the power supply after opening the cover.
5.5 安裝維修時應妥善保護隔爆面,將其清理后涂204-1置換型防銹油。
To properly protect the explosion-proof surface 5.5 installation repair, to clean up after the replacement of anti-rust oil coating 204-1.

專業生產:防爆配電箱,鑄鋁防爆箱,不銹鋼防爆箱,防爆接線箱,防爆照明配電箱,防爆動力配電箱,防爆配電柜,防爆控制箱,BZC51防爆操作柱,防爆應急燈,防爆熒光燈,防爆無極燈廠家,防爆正壓柜,防爆投光燈,柳市防爆箱,防爆斷路器等,質量三包,凡購買本公司產品,質保三年,本公司證件齊全,價格實惠!

www.shbxmd.com www.zj8899.com www.jiang-ex.com www.fangbaoa.com www.zj-88.com  www.wcfangbao.com  www.exbaidu.com www.wzfangbao.com


感興趣的產品PRODUCTS YOU ARE INTERESTED IN

智慧城市網 設計制作,未經允許翻錄必究 .? ? ? Copyright(C)?2021 http://www.cmr6829.com,All rights reserved.

以上信息由企業自行提供,信息內容的真實性、準確性和合法性由相關企業負責,智慧城市網對此不承擔任何保證責任。 溫馨提示:為規避購買風險,建議您在購買產品前務必確認供應商資質及產品質量。

會員登錄

×

請輸入賬號

請輸入密碼

=

請輸驗證碼

收藏該商鋪

登錄 后再收藏

提示

您的留言已提交成功!我們將在第一時間回復您~