| SPECIFICATIONS | | ANALOG INPUT AND A/D CONVERSION | | Load cell excitation | 10VDC±5%, 320mA | | Input Sensitivity | 0.45?/D | | Zero adjustment range | -0.6mV~+42mV : combinations of 6bit dip switch | | Input | voltage | Max. 32mV | | impedance | 10? (Min.) | | noise | 0.6?p.p or Less | | A/D converter | type : dual slope type
resolution : 1/65,000 counts(16bits)
converting speed : 20times/sec | | Non-linearity | 0.01% of full scale | | Temperature-drift | zero ±20PPM/℃
span ±20PPM/℃ | | Overload tolerance | +10% of full capacity | | Display update rate | 20 times/sec | |
| DIGITAL SECTION | | Display unit | 12.7mm(1/2"), 7digits
highly bright fluorescent tube
sub display : 7segment 12digit Red-FND
size : 9.2(H)x4.8(W)mmx1line | | Annunciators | steady, zero, tare, gross, sp1, sp2, run | | Decimal point position | 0, 0.0, 0.00, 0.000 | | Keyboard | ten key, zero, net/gross, tare, formula, bin, run/stb, final, drib, free fall, clear, print, enter | | External input signal | opical-isolator | | min. Division | x1, x2, x5, x10, x20, x50 | | max. Display | +550,000 | | Rear panel | Loadcell input : 5pin connector
Remote control : 5pin input terminal (start, stop, tare, tare reset, zero)
BCD input : 37pin connector
C ontrol relay : 7pin terminal (final, drib, finish, batch finish, zero)
25pin : connector : 8pin control | |
| GENERAL | | Data memory back-up | appr. 10year | | Power | 100/117/120/220/240V AC, ±10%, 50/60? (factory preset) | | Power consumption | appr. 30VA | | Operating condition | temperature : -10~40℃ (14~104℉)
humidity : 85% Rh Max. (non-condensing) | | Net weight | 2.4kg | | Gross weight | 3.1kg | | Physical dimensions | (WxDxH) 200x175x105mm / (WxDxH) 7.87x6.89x4.33inch | | Fuse | 250V/1A | |
| | OPTION | | OP1 | Printer I/F : Centronics Parallel | | OP2 | Analog Out : V - out(0~10V) | | OP3 | Analog Out : I - out(4~20mA) | | OP4 | Serial I/F : RS 422, RS485 | | OP5 | BCD Data Out-put | | ※RS-232C and current loop : standard installed | |
| | DIMENSIONS | | | Applications | |
|
