通信電纜 網絡設備 無線通信 云計算|大數據 顯示設備 存儲設備 網絡輔助設備 信號傳輸處理 多媒體設備 廣播系統 智慧城市管理系統 其它智慧基建產品
蘇州全迪亞電子科技有限公司
蘇州全迪亞電子科技有限公司
Low bａnd corner frequency 達1Hz,可支持 功率因數控制器(PFC)之穩定性測試5MHz帶寬足以量測大多數電源和穩壓器超高頻寬,可達23 Octave優異精確的低失真表現5Ω終端,對待測電路的影響降至最小包括衰減功能來確保小信號的測量正確性
Low bａnd corner frequency 達1Hz,可支持 功率因數控制器(PFC)之穩定性測試
5MHz帶寬足以量測大多數電源和穩壓器
超高頻寬,可達23 Octave
優異精確的低失真表現
5Ω終端,對待測電路的影響降至最小
包括衰減功能來確保小信號的測量正確性
產品說明
The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the FRA inputs require attenuation probes.
The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.
The bandwidth of the transformer is strongly related to the terminating impedance. The most network analyzers provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.
規格
| Performance at -10dBm input level | |
| Characteristic | Rating |
| DCR | |
| Ratio | 1:1 |
| Termination Impedance | 5 Ohms |
| Usable Bandwidth | 1Hz - 5MHz (Terminated into 5 Ohms) 10Hz - 5MHz (Terminated into 50 Ohms) |
| Isolation Voltage | 600V |
| Isolation Capacitance | 390pF@1KHz |
| DC Current | 10mA |
| Temperature Range | 0 ~ 50°C |
| Maximum Altitude | 6000 Ft |
Note: The upper end of the bandwidth is heavily dependent on the interconnect between the Injector and the DUT.
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
智慧城市網 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
